Timecode to frames, frames to timecode, seconds, timecode addition and subtraction, frame rate conversion and a frames per second calculator, at every video frame rate, drop frame included.
Everything is computed in your browser: nothing is sent or stored.
Type a value in any of the three forms: the other two are worked out.
Timecode A plus or minus timecode B, at the same rate. The result can be negative.
A duration or timecode from one rate to another, two ways: keep every frame (a conform, the duration changes) or keep the real-time duration (the frame count changes).
Same frames (conform)
00:57:36:00
86,400 frames · duration 00:57:36.000
Same real time
01:00:03:15
90,090 frames · duration 01:00:03.600
A frame count and a duration give the frame rate.
A timecode reads HH:MM:SS:FF: hours, minutes, seconds and frames. The last field counts up to the rate's timebase minus one: 0 to 24 at 25 fps, 0 to 23 at 23.976 and 24, 0 to 29 at 29.97 and 30.
The NTSC rates (23.976, 29.97, 59.94) really are 24000/1001, 30000/1001 and 60000/1001 frames per second, yet their timecode counts on 24, 30 or 60. One hour of 23.976 non-drop timecode therefore lasts 3603.6 real seconds, 3.6 seconds more than the wall clock. The calculator shows both durations.
Drop frame timecode (DF, written with semicolons, 01;00;00;00) makes up that gap at 29.97 and 59.94: it skips the labels 00 and 01 (00 to 03 at 59.94) at the start of every minute, except every tenth minute. No picture is dropped, only frame numbers, and the timecode stays within milliseconds of the clock.
One hour of 29.97 drop frame timecode is 107,892 frames, against 108,000 non-drop. Drop frame does not exist at 23.976: it is only defined at 29.97 and 59.94 (SMPTE 12M). A skipped label such as 00;01;00;00 is rejected by the calculator, as your editing software would reject it.
Moving an edit from 23.976 to 25 can be done two ways. A conform keeps every frame and plays it faster: the frame count stays, the duration gets about 4% shorter and the sound has to be adjusted. Keeping real time keeps the duration and changes the frame count, which means repeating or blending frames.
The third block of the calculator gives both results side by side. For a whole edit, PR2XML converts the project itself (sequences, clips, markers) between Premiere Pro, DaVinci Resolve and Final Cut Pro, at the sequence's frame rate.
One hour of timecode (01:00:00:00) is 86,400 frames. One hour of real clock time is 86,314 frames (3600 x 24000/1001, rounded), because each frame lasts slightly longer than 1/24 of a second.
107,892 frames for 01;00;00;00. Non-drop, 01:00:00:00 is 108,000 frames and lasts 3603.6 real seconds.
Divide the frame count by the duration in seconds. 1440 frames in 60.06 seconds is 23.976 frames per second. The last block of the calculator does it and names the nearest standard rate.
Yes for drop frame: the calculator uses the same timecode functions as the PR2XML converter, which writes the timecodes Premiere Pro and DaVinci Resolve read. Drop frame labels follow SMPTE 12M.
No. Every calculation happens in your browser; the page even works offline once loaded.